Publicité
Les langues disponibles
Les langues disponibles
1a. If the screen has a flat back, attach the vertical parts of the bracket to
F
E
1b. If the screen has a curved back, or if it is wished to space the TV
C
G
E
Check that the screws used have the correct threads to fit properly into
the female threads on the screen. The loop of steel cable should be
between the two top fixing points. Do not drill into the back of the screen.
2. Attach the two parts of the wall hanger
together.
3. Draw a horizontal line where the centre of the
screen will be, and then draw a parallel line 230
mm above it.
DO NOT use plasterboard fixings - they will not support the weight of the
screen. If fixing to a plasterboard wall, make sure that the wall hanger is
fixed through the plasterboard to the wooden studding that supports the
wall.
INSTALLATION
the mounting holes in the screen using the
12 mm machine screws, plain washers and
shakeproof washers as shown. Check that
the screws used have the correct threads to
fit properly into the female threads on the
screen. The loop of steel cable should be
between the two top fixing points. Do not
drill into the back of the screen.
115mm
Mark a point at centre, and drill a
hole with a masonry drill. Insert a
wall-plugs.
Fix the wall hanger to the wall
using a woodscrew.
Page 3
further from the wall, attach
the vertical parts of the
bracket to the mounting
holes in the screen using
the
16
mm
screws, plain washers and
shakeproof
inserting the spacer [C]
between the bracket and
the back of the screen.
machine
washers,
Publicité
