Publicité
Les langues disponibles
Les langues disponibles
5. Mount the Touch Module at the Top of the Screen
•
Built-in magnets are loaded on the rear face of the touch module as the factory default
setting. No need to secure the touch module by screws on a screen or a white board that
attracts magnets.
•
For using the touch module on a screen or a white board that does not attract magnets,
remove the built-in magnet from the rear face of the touch module and secure the touch
module with commercially available screws.
•
Use commercially available screws (2 pcs) in nominal diameter 3 mm. Prepare bolts that
are appropriate for your circumstances.
•
Project the adjustment screen in the software program. The center position adjustment line
would be displayed, Align this with the centering line on the touch module.
•
Refer to page 5 about the touch module mounting procedures by the table projection
mount unit.
Note:
• Do not connect the USB cable before mounting the touch module onto the screen.
[1] Decide the position to mount the touch module referring the below picture.
Over 100 mm / 4 inches
Screen
Over 25 mm / 1 inch
Projection area
* Pay attention to mount not to cut into the projection light.
[2] Mount the touch module onto the screen.
Mounting by the built-in magnets
• Put the rear face of the touch module onto a screen or a whiteboard since the touch module
has built-in magnets on its rear face as the factory default setting.
• In case, mounting the touch module by the built-in magnets, take appropriate countermeasure
from falling down. Prepare the commercially available Kensington security wire and connect it
to the security slot on the touch module.
Touch module
*
25mm - 100mm
/ 1 - 4 inches
Over 25 mm / 1 inch
ENG-10
Over 25 mm / 1 inch
Publicité
