Fimar AB.8/D Emploi Et Entretien page 10

Using the grater
•
In combined mincer-grater models, remove the mincer set before using the grater.
•
Lift the grater lever and place the product to be processed inside the grater mouth.
•
Lower the grater lever and press the switch on position "I".
•
Gradually press the lever until the product is finished.
•
In order to stop the machine, press the switch on position "0".
•
At the end of processing lift the lever and introduce more product into the grater mouth; lower the lever
once more and press the switch on position "I".
•
At the end of the work session press the switch on position "0".
•
At the end of the work cycle, grate a piece of hard bread or use the appropriate brush to clean the roller.
Using the mincer
•
In combined grater-mincer versions, lower the grater lever.
•
Tighten the filler knob.
•
Tighten the handwheel on the output mouth of the mincer without blocking.
•
Start-up the machine by pressing the switch on position "I".
•
Place the product inside the upper mincer mouth and press it down using the pestle supplied.
•
At the end of the work session press the switch on position "0".
•
At the end of the work cycle remove the mincer set and wash using suitable detergents in hot water.
Dismantling the mincer set
Mod.AB.8/D – TR.8/D:
•
Remove the hopper from the upper mouth.
•
Rotate the handwheel anti-clockwise.
•
Extract:
the mincing plate;
-
the blade;
-
and the volute, in sequence
-
•
Unscrew the filler knob by turning anti-clockwise
and extract the mincer filler.
•
Perform operations
reassemble the mincer group.
INFORMATION: Prior to each work cycle ensure that the removable parts are properly fixed
in reverse order
to the machine.
OPERATION AND
to
6
CLEANING
3