Jeulin EVO2 R15/2A Manuel D'instructions page 4

Test and Measurement
EVO2 R15± / 2 A power supply
Ref: 281 486
1 Description
1
2 Setting up
• Connect the power supply to the 230 V mains supply.
• Set the voltage and current buttons to the left (minimum value).
• Connect your circuit (lamp, motor, voltage divider, etc.) to the selected output sockets.
• Toggle the master switch (2) to " I ". The power-on indicator lamp and the 2 displays light on.
• Adjust voltage and current to desired values.
3 Precautions for use
• Avoid using the power supply in direct sunlight or close to a heat source.
• Never block the ventilation vents when the power supply is operating.
• If this device is used in a manner not mentioned in these instructions, the safety ensured
ENGLISH
1 – Plastic box with double insulation
2 – On / off switch
3 – Voltage adjustment -15 V to +15 V
4 – Output sockets -15 V to +15 V
5 – External control switch
6 – External input sockets
by the device may be compromised.
5
4
6
3
2
3