Publicité
Assembly And Hook-Up Information
1. These heaters are packaged completely. Propane cylinders (tanks)
are not included with these heaters.
2. Remove heater from carton.
3. Use only vapor withdrawal LP gas cylinders constructed for use
with propane only (HD-5) and marked in accordance with the
specifications for LP gas cylinders of the U.S. Department of
Transportation (DOT SPEC. 39).
4. This heater must be used only with a vapor withdrawal LP gas bulk
tank equipped with a standard POL valve – do not use this heater on
bulk tanks greater than 20 pounds LPG capacity (50 pounds water
capacity).
5. Dual Burner Model
• Assembly of this item requires a Phillps screw - driver.
• The tank collar bracket must be assembled before the heater
can be attached to the propane tank.
• Align bolt holes in tank collar bracket with bolt holes in center
plate on manifold such that the heater is facing outward once
attached to cylinder collar.
• Attached with screws removed above, making sure that tip
switch bracket is between tank collar bracket and manifold
center plate.
• Place heater onto tank with tank collar bracket over tank collar.
Mounting bolt knob should be positioned to the outside of tank
collar.
• Firmly secure to tank by hand-tightening mounting bolt knob. Do
not overtighten.
• Make sure heater regulator is in the "OFF" position.
• Insert regulator's connector into tank's valve and turn left
(counter clock-wise) with hand as much as possible. Do not
overtighten.
Single Burner Model
• Be sure heater is facing away from tank.
• Insert regulator connector into tank valve outlet fitting and turn
left (counter clock-wise) until fully tightened. Do not overtighten.
• Place heater support around venturi and slide clip ends onto
propane cylinder collar. Use 1/4"-20 x 35mm screw and wing nut
to secure heater support onto venturi tube.
6. Operate only on a stable, level surface.
7. Open propane tank valve slowly.
8. Check all fittings for leaks. Apply a 50/50 mixture of liquid soap and
water to all joints. Bubbles forming indicate a leaking connection.
Correct all leaks before proceeding.
WARNING: Never touch heater while in operation to avoid injury. Move
heater by grasping the propane cylinder carefully.
9. The heater should be inspected before each use and at least
annually by a qualified service person.
10. The hose assembly shall be visually inspected prior to use of heater.
If it is evident there is excessive abrasion or wear, or the hose is cut,
it must be replaced prior to the heater being put into operation.
Replacement hose assembly shall be REDSTONE hose assembly as
listed in the parts list.
11. Minimum inlet gas pressure is 20 psi.
12. Maximum inlet gas pressure is 120 psi (equivalent to an ambient
temperature of 75°F (24°C)).
All manuals and user guides at all-guides.com
3
Publicité
