Nash siren R3 Manuel De L'utilisateur page 3

LED flash only: Receiver muted. LEDs on. No sound
and no vibrate.
Beep, LED flash and Vibrate: Sound, LED and vibration
turned on.
LED flash and a bleep: Sound and LEDs on.
Anti-Theft Alarm: Short press of A button. Two bleeps
will be heard. An increasing pitch signifies Anti-Theft is
ON. Decreasing pitch is Anti-Theft OFF. Factory setting
is Anti-Theft Alarm OFF.
The Anti-Theft alarm alerts you if an R3 head is turned
off whilst your Receiver is on. Once triggered, a short
press of the A button stops the alarm sounding. The
Anti-Theft feature will then need to be re-set on the
head that triggered the alarm.
Programming R3 Heads to R3 Receiver:
1. Press and hold Power and Volume buttons together
for 3 seconds until a bleep is heard.
2. LED 1 will light and stay lit. Sounding an R3 alarm
will pair it to that channel. Pairing is confirmed when
the LED on the Receiver flashes. Short press the Power
button to light the second LED. R3 alarms can be
sequentially paired in this way through channels one
to four.
3. Once you have paired all the R3 heads you require
press and hold Volume and Power buttons for 3
seconds to exit programming, signified by a double
bleep.
4. The fifth channel can be paired with up to 32 different
R3 alarms. To pair R3 heads with the fifth channel enter
programming mode by pressing and holding Power
and Volume buttons together for 3 seconds until a
bleep is heard.
P4
All manuals and user guides at all-guides.com
SIREN R3 USER MANUAL
5. Short press the Volume button, and the fifth LED on
the Receiver will light and stay lit. When an R3 alarm
sounds and is successfully paired the LED flashes. Short
press Volume button and the LED lights and stays lit,
ready to pair with further R3 heads on the same channel.
Once you have paired all the R3 heads you require
press and hold Volume and Power buttons for 3
seconds to exit programming, signified by a double
bleep.
Erasing programmed R3 heads from the R3 Receiver:
1. Press Power and Volume Buttons together, without
releasing. After 3 seconds the first LED will light and a
bleep will be heard.
2. Continue to keep both buttons depressed together
for a further 3 seconds, until three consecutive bleeps
are heard and the LED turns off. This signifies any
existing pairings with R3 alarms have been erased.
Note individual heads cannot be selected and erased
from the R3 receiver, all pairings have to be erased.
3. You can then go back into pairing mode by pressing
Power and Volume together until you hear a single
bleep and the first LED lights. Now pair your heads
accordingly.
NOTE: When in pairing mode, if no signal from an R3
head is registered within 10 seconds the R3 handset
returns to normal operation.
OPERATING FREQUENCY: Within the 868MHz
European Licence Exempt Band.
Ambient operating temperature of +40C -10C.
Protect against water ingress, do not immerse.
Thank you for purchasing your Siren R3 bite alarms &
Receiver. We never forget our customers' support.
P5
batteries
SIREN R3 USER MANUAL