APEX FORGE V1 Mode D'emploi page 5

Extend and fold the leg. (Fig 4,5)
Each Leg section can be adjusted to the desired length by opening the
Flip Lock Lever so the Leg is free to slide in or out. Once the desired
length is achieved, snap the Flip Lock Lever closed, so that the Leg
Section is securely locked. Repeat this step for each Leg and each
Section until the Tripod is set to the desired height.
Warnings:
Do not exceed the tripod's maximum load capacity
Ensure the ball head is locked
Do not operate this tripod when the temperature is below -20°C or
above 70°C. It is not commended to operate in saltwater.
Do not put this tripod in sunlight or lean against the glass of car for
a long time
- 03 -