Furman PST-10D Manuel page 6

All manuals and user guides at all-guides.com
switch, but the (3) delayed AC outlets will be energized and turned
off by your remote 12V sens circuit. 12 volts (+/- 2V) must be present
for the delayed outlets to energize from a remote sens trigger.
Telco – Satellite – Cable Transient Voltage Surge Suppressors:
The PST-10D features transient voltage surge suppression for both
standard telephone lines, as well as cable and satellite lines utilizing
standard coaxial connectors. As these surge suppressors are in-
line, they will require an additional cable to connect from their output
to the control device requiring protection.
All in-line surge suppressors feature our exclusive ground
contamination free technology. This aids in eliminating audio
buzzing, and the video hum-bars that can result from typical in-line
suppressors. Further, our cable and satellite suppressors are TIVO
friendly as well as HD-Digital Television ready. Both DC carrier
signals as well as high bandwidth signals can pass through our
circuit. In fact the bandwidth is less than 0.1dB loss at 1GHz!
To connect your cabling to these in-line protectors, simply follow the
in and out indications marked next to the Telco, Cable and Satellite
connectors.
Note:It is not possible to make an in-line cable or satellite protector
"maintenance-free" as we have accomplished with the 120 VAC line.
This would necessitate limited signal bandwidth that would not allow
the signal to pass. Under extreme conditions, it is possible that the
surge suppression in one of these devices could sacrifice itself after