Publicité
Les langues disponibles
Les langues disponibles
EMX 108 002
EN
LED STRIP 230V 50 M
Accessories included : plastic drum, x 2 power supply kit
The installation instruction does not superseeds local and (inter)
national regulations for electrical installations
• The product must be installed by a professional electrician fol-
lowing applicable and appropriate electrical standards and the
instructions provided by the supplier in order to avoid any risks
of fire or electrical shock
• Before installation, maintenance or cleaning, always first turn
off power to the circuit.
SAFETY INSTRUCTIONS
In order to facilitate the installation process and ensure product
performance, follow the installation procedure according to the
following safety rules:
• Carefully unpack the product and ensure there are no damages.
Return the product to the supplier if damages are noticed
• Do not attempt to repair the product since doing so may avoid
the warranty. Contact your local reseller for technical assistance.
• Keep at an ambient temperature of: -25 °C to +45 °C.
TROUBLESHOOTING
Absence of light:
• Check that the product and its accessories are correctly ins-
talled.
• Check if the power supply is connected.
If the product still does not work, contact the local retailer to ob-
tain technical assistance. Do not attempt to repair the product,
as doing so will void the warranty.
Plug
IP 44
IP 65
USER MANUAL
Unroll the entire LED strip and connect the power plug to the
power supply. IN CASE OF A CUTTING OF THE LED STRIP, THE
SEALING OF THE ELECTRICAL CONNECTION IS NO LONGER
ENSURED.
The LED ribbon is scored every 1 meter. To cut the LED strip,
make sure that the product is turned off.
1 / Cleanly cut the ribbon at the indicated place (symbol chisel
every meter).
2 / Insert the pin connector by placing the points in the 2 conduc-
tive wires of the LED strip.
3 / Make sure that the pin connector is correctly attached as an
extension of the LED strip.
4 / Insert the other end of the pin into the 230 V rectifier connec-
tor supplied with the power kit. Use the glue provided to seal the
connection.
5 / Make sure that the new connection is correctly plugged and
in the right direction.
6 / Add the end cap at the end of the LED strip and connect it
firmly with the glue provided.
Exe_Notice_EMX108002_v2.indd 2
Rectifier 230 V AC
Front connector
BIZLINE SAS PARIS - FRANCE
CLEANING/MAINTENANCE
To optimize lighting, clean optical components and aluminum
ring which reflect the light regularly, once the power has been
switched off and the product has cooled down.
• Never use chemical products for cleaning.Washability: use wa-
ter jet or soapsuds.
• Do not cover with thermal insulation materials
INSTRUCTIONS
• Do not light the product when the tape is wrapped around the
drum. Unroll the entire LED strip before use.
• Operating voltage 220-240 V. Connect the product to a stable
electrical installation, protected from overvoltages and leaks.
• Do not carry out maintenance or other operations when the
product is live. Risk of electric shock.
• Do not connect more than 50 meters of LED ribbon as a result.
• Do not place the 230V rectifier in a damp place or in water.
• Do not install the product in a flammable or explosive environ-
ment.
• Do not fix the LED strip with a metal bracket.
• Do not bend or twist the ribbon with a bending diameter less
than 8cm
• Do not install the LED strip in a confined environment.
• Do not cover or wrap the LED strip.
• Do not crush or apply pressure to the tape during use.
LED strip
Max 50 M
1
3
5
End cap
2
4
6
01/04/2019 15:47
Publicité
