AquaScape IonGen System G2 Mode D'emploi page 5

• Insert IonGen Probe cord through the IonGen Probe collar
(Ex. 8).
• Hand-tighten the IonGen Probe collar into position (Ex. 8).
• Plug the connector from
the Control Panel into
the IonGen Probe fitting
connector (Ex. 9).
Option B: Only Using
IonGen Probe Holder
• The IonGen Probe can also
be submerged in a filter by
using the IonGen Probe
Holder.
1. Position the probe holder bracket in the desired
location on check valve or plumbing (Ex. 10).
2. Pull the buckle securely fastening the probe holder in
place.
3. Trim away remaining or excess strap if necessary.
4. Position the IonGen Probe into the probe holder.
IMPORTANT: The IonGen Probe must be fully
submersed in water at all times to function
properly. Failure to provide sufficient water flow
across IonGen Probe will affect the IonGen
System's performance. See Troubleshooting for more
information.
☎
aquascapeinc.com | CAN (866) 766-3426 |
NOTE: The IonGen System may be used for algae control
in ponds or fountains containing fish as long as the copper
concentration is carefully monitored and the concentration
is not allowed to exceed 0.25 ppm.
NOTE: If the total alkalinity of the water is less than 100
ppm, you'll need to increase the level of alkalinity. DO NOT
operate the IonGen System on water features with fish if
the alkalinity levels are below 100 ppm.
Ex. 7
NOTE: If the total alkalinity of the water is above 250 ppm
you will need to decrease the level of alkalinity. If alkalinity
is more than 250 ppm it can be typically reduced by
conducting a partial water change. Check to make sure
your tap water is within the target water parameters.
NOTE: Alkalinity (not hardness) can be determined using
the KH/Alkalinity Test Kit (part #96019). Alkalinity levels
outside of the recommended parameters will significantly
reduce and possibly eliminate the effectiveness of the
IonGen System to control the algae. See Targeted Water
Parameters section for more information.
Ex. 8
STEP 3
SETTING THE IONGEN
• Turn on the pump and plug in the IonGen System (Ex. 11).
• Adjusting the IonGen System's Level - Depress the "+" or
"-" button for 3 seconds to enter the setting mode. Once
in the setting mode the ionization level can be adjusted
(Ex. 12). The setting mode will exit automatically.
Ex. 9
• If operating the IonGen System on a new water feature
or a water feature with good water quality and little to no
algae, set the IonGen System to level 1 or 2. Follow the
next step if algae growth begins to increase.
Ex. 10
on the low level will make sure the copper levels don't
become too elevated, and also prolong the life of the
IonGen Probe.
☎
US (866) 877-6637
SYSTEM'S LEVEL
™
Ex. 11
IMPORTANT: Operate the IonGen System at a
low level and only raise the ionization level if the
algae attached to rocks and gravel becomes
excessive. Maintaining the IonGen System
Ex. 12
5