JAPANNEXT JN-IPS320UHD Manuel D'utilisation page 6

Put the monitor face down on a stable and smooth surface, pay attention not to damage or scratch the front glass /
screen. It's better putting a soft piece of cloth on the table beforehand to protect the monitor. Make sure the monitor
is unplugged before starting installation.
1. Put the monitor face down on a stable and smooth surface.
2. Position one foot against the underside of the monitor by placing the longest part backwards and use 2 supplied
screws to fix it. Screw without force.
3. Position the second foot against the underside of the monitor by placing the longest part backwards and use the
2 remaining screws to fix it. Screw without force.
4. Make sure the stand and base are firmly attached.
5. Make sure both monitor and computer are unplugged.
6. Plug power cord and signal cable (HDMI or VGA or DP etc..) to the monitor.
7. Plug the computer and monitor power cord to the power supply.
8. Turn on the monitor and computer.
After turning on computer and monitor if no image is displaying make sure you have chosen the right signal cable.
Please fasten signal cable finger screws at each end of cable (only VGA).
Please make sure to earth the power cord.
QUICK START GUIDE
SETTING UP THE MONITOR
NOTE / CAUTION
6