Publicité
Les langues disponibles
Les langues disponibles
11
11G
11F
11B
11D
11E
11D
11B
11B
11A
11 HOSE CONNECTION
From underneath sink, push the Center Connector (11A) onto receiving Tube (11B),
until unable to push any further. Pull down on the quick connect housing (11A). If the
housing and the Inner Collet (11C) separate slightly but do not pull off receiving Tube
(11B), the connection is secure.
Slide the End Connectors (11D) with arrow (11E) pointing up onto the Valve Bodies (11F).
Push the End Connectors (11D) all the way up until completely seated. Be careful not
to damage O-Rings (11G).
12
12A
12 POP-UP INSTALLATION
Install and adjust Pop-Up (12A) using separate instructions supplied with the Pop-Up
assembly.
11G
11F
11A
11D
11B
11C
11C
11A
ENGLISH
13
13D
13C
13A
HOT
13D
13 WATER SUPPLY CONNECTIONS
First, thread Inlet Connectors (13A) into Water Supply Lines (13B). Then, insert Inlet
Connectors (13A) into Valve Bodies (13C). Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer's instructions when installing supply lines. Next, insert Clips (13D) into
Valve Body Holes (13E), to secure unit.
WARNING: Do not twist Inlet Connectors (13A) once installed!
4
13C
13D
13B
13A
13B
COLD
13E
Publicité
