Publicité
Les langues disponibles
Les langues disponibles
If your heater fails to operate, please follow these procedures before contacting customer services:
Problem
Probable Cause
The room temperature has
warmed up to thermostat setting.
Heater is not plugged into a 120V
Unit is not
polarized outlet/receptacle.
heating.
Thermal Cut-Off has temporarily
turned off the heater due to high
temperatures.
A drop of oil fell on the heating
coil during the manufacturing
process. It will quickly evaporate
The heater is
and should not occur again.
creating a
Check & ensure there are no
burning smell.
combustible materials within 0.9
meters (3 feet) surrounding the
heater.
The heater is
blowing air, but
The fan-only function is on.
it's not warm.
If the problem still persists, refer to the warranty. For more information, call 1-800-268-7622 for service or visit
www.super-electric.com.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO COULD VOID
THE WARRANTY AND CAUSE DAMAGE OR PERSONAL INJURY.
H1C0091SNB/H1C009WSNB
Bellagio By Airworks
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Solution
Adjust the thermostat control knob to a higher setting. For
more information on using the thermostat, refer to page 6.
Ensure unit is in OFF position. Plug in unit and attempt to turn
on again.
Unplug the heater and turn off; allow it to cool for 20-30
minutes. Once heater has cooled off, check to make sure
there are no objects on or very close to the unit. To resume
operation, plug unit back in once it has cooled off.
Ensure room in which heater is situated is well ventilated.
Remove any combustible items from around the heater.
At this setting, the unit will help circulate the air and will not
produce heat. For more information, refer to page 6.
Publicité
