Accessories - Milwaukee 9667-20 Manuel De L'utilisateur

3 and 5 Ton Hand Chain Hoists
The load chain must have an odd number of links. After attaching the
chain to the loose end pin, operate in the hoisting direction until the load
end of the chain is approximately 5 feet (1.5M) long. Run the chain
through the hook block (first link around the sheave must stand on edge)
and up to the dead end block. Secure chain to dead end block using the
stud, nut and cotter pin. Refer to Fig. 9.
Fig. 9
Reeving 3 and 5 ton hoist
To reduce the risk of injury, check each stage of
reeving the chain to be sure it has no twists. On the
3 and 5 ton units, twisted load chain will cause the
chain to jam in the liftwheel or sheave wheels and
this may break the chain and allow the load to
drop.
Testing
Before use, all altered, repaired or used hoists that have not been oper-
ated for the previous 12 months should be tested by the user for proper
operation. Test the unit without a load and then with a load of 50 pounds
(23Kg) times the number of load supporting chains, to be sure that the
hoist operates properly and that the brake holds the load when the hand
chain is released. Then test with a load of 125% of rated capacity. Hoists
in which load sustaining parts have been replaced should be tested with
a load of 125% of rated capacity by, or under the direction of, an ap-
pointed person and a written report prepared for record purposes.
Repairs
If your hoist is damaged, call 1-800-414-6527 for assistance.
page 8
Loose end
pin
Dead end
block
WARNING!

ACCESSORIES

To reduce the risk of injury, always unplug the
tool before attaching or removing accessories.
Use only specifically recommended accesso-
ries. Others may be hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric
Tool catalog or go on-line to www.mil-electric-tool.com. To obtain a cata-
log, contact your local distributor or a service center listed on the back
cover of this operator's manual.
FIVE YEAR TOOL LIMITED WARRANTY
Every MILWAUKEE tool is tested before leaving the factory and is war-
ranted to be free from defects in material and workmanship. MILWAUKEE
will repair or replace (at MILWAUKEE 's discretion), without charge, any
tool (including battery chargers) which examination proves to be defec-
tive in material or workmanship from five (5) years after the date of
purchase. Return the tool and a copy of the purchase receipt or other
proof of purchase to a MILWAUKEE Factory Service/Sales Support
Branch location or MILWAUKEE Authorized Service Station, freight pre-
paid and insured. This warranty does not cover damage from repairs
made or attempted by other than MILWAUKEE authorized personnel,
abuse, normal wear and tear, lack of maintenance, or accidents.
Battery Packs, Flashlights, and Radios are warranted for one (1) year
from the date of purchase.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED HEREIN ARE
EXCLUSIVE. IN NO EVENT SHALL MILWAUKEE BE LIABLE FOR ANY
INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, INCLUDING
LOSS OF PROFITS.
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRAN-
TIES, OR CONDITIONS, WRITTEN OR ORAL, EXPRESSED OR IMPLIED FOR
MERCHANTABLILITY OR FITNESS FOR PARTICULAR USE OR PURPOSE.
This warranty gives you specific legal rights. You may also have other
rights that vary from state to state and province to province. In those
states that do not allow the exclusion of implied warranties or limitation
of incidental or consequential damages, the above limitations or exclu-
sions may not apply to you. This warranty applies to the United States,
Canada, and Mexico only.
WARNING!