Installation Requirements; Tools And Parts; Installation Instructions; Prepare Internal Blower System - KitchenAid UXB1200DYS Instructions D'installation

INSTALLATION
REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Phillips screwdriver
■
Parts supplied (600 CFM models)
Remove parts from packages. Check that all parts are included.
Blower assembly
■
Motor support bracket
■
Motor spring clip
■
Two 6 x 1 mm nuts
■
Five 4.2 x 8 mm screws
■
Two 6 x 16 mm screws
■
Two 6.4 x 11 mm lock washers
■
T-20 Torx adapter
® ®†
■
Parts supplied (1200 CFM models)
Remove parts from packages. Check that all parts are included.
Blower assembly
■
Motor support bracket
■
Motor spring clip
■
Five 6 x 1 mm nuts
■
Five 4.2 x 8 mm screws
■
Five 6 x 16 mm screws
■
Five 6.4 x 11 mm lock washers
■
T-20 Torx adapter
® ®
■
†TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC
® ®
4
INSTALLATION
INSTRUCTIONS

Prepare Internal Blower System

IMPORTANT: Perform steps 1-4 before mounting the range
hood.
1. Remove grease filters from range hood. See the "Range
Hood Care" section in the Use and Care Guide.
2. Install the motor support bracket using three 4.2 x 8 mm
screws. Screw bracket to the inside top or back (alternate
location on some models), toward the left side of the range
hood.
3. Install motor spring clip using two 4.2 x 8 mm screws. Screw
spring clip to the inside top or back (alternate location on
some models) of the range hood at the proper location for
the selected motor system. Slide the mounting tab of the
spring clip through the slot in the panel and secure with the
screws. Use the inside set of mounting holes for the single
motor system. Use the outside set of mounting holes for the
dual motor system.
B
A
A. Three 4.2 x 8 mm screws for motor support bracket
B. Two 4.2 x 8 mm screws for motor spring clip
C. Motor support bracket
D. Motor spring clip (single motor assembly location)
E. Motor spring clip (dual motor assembly location)
D
C
E