Hubbel PD2806 Directives De Montage

Hardware:
Drywall Screw
Qty.5
Installation Tips:
• Preferred method of installation is to screw directly to wall studs.
• The provided anchors are intended for wall mounting when not
utilizing wall studs. In this case, use of all four wall anchors are
required.
• Ultimate holding value is determined by age, condition & capacity of
wall material and installation type.
Suggested Tools:
Bubble Level
Phillips Screwdriver
Assembly:
0
After removing contents from box, using a level, place the wall
mount bracket at desired height and make sure it is level.
0
e
Using drywall screws secure wallmount plate to wall.
•
'--- - -
0
-
-
- -
�
0 0 0
*Drywall anchors are optional in this step, but not required.*
Charging Station
Installation Instructions
Wall Anchor
Qty.4
3/16" Drill Bit
@
•
'
-.
t
e
Slide the charging station into the mount by guiding the
technolgy box down into the mounting plate.
0
Secure the last screw into the hole on the mounting plate above
the technology box.
e
Now that the charger is secured to the wall, it can be plugged in.
The power cable will plug into the bottom of the charging`
station and into any standard wall outlet or power strip.
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
Shelton, CT 06484
1-800-288-6000
www.hubbell-wiring.com
PD2806 (Page 1) 02/17
English
lx