ChargeXpert Mode 2 Mode D'emploi page 6

ABOUT THE CONTROL BOX
The control box has the following protective features:
Leakage protection
▪
Over-voltage/under-voltage protection
▪
▪ Overheat protection
Overload protection
▪
If any of these protective features are enabled, the control box would stop the charging process. Once the
charge has stopped, the control box will perform a self-check to ensure the right operating conditions are
met so that it can restart. If over-voltage or under-voltage has been detected, you will need to disconnect
the cable first. Then reconnect to the correct voltage supply.
LED/LCD Display description
Condition LED Display status
Lights Red (fault)
Initial mode Light off
Waiting Connection Light off
Charging mode Light off
Charging completed Light off
Fault Twinkle
Display LED display: Shows all the charging dates:
Power/Voltage/Current/Time/Status
Switch Charging: Indicates that the charge is taking place.
Red light Fault mode
Green light 1 Initial mode
Green light 2 Status 1
Green light 3 Status 2
Green light 4 Status 3
Green light 5 Status 4
Green (1)
Light on
Light on
Light on
Light on
Light off
Green (2) Green (3)
Light off Light off
Light on Light on
Racing light Racing light
Light on Light on
Light off Light off
Green (4) Green (5)
Light off Light off
Light on Light on
Racing light Racing light
Light on Light on
Light off Light off