Cooper Greengate LK 16 FK Instructions D'installation page 2

Mounting Instructions
3. Slide the flushmount assembly over the open enclosure
until the flange is resting flush with the wall and there
are no gaps between the flange and the enclosure.
4. Make sure that the circular holes on the sides of the
flushmount kit line up with the smaller circular holes
that the logic board mounts in and that the lock hole are
lined up. The 16 size enclosure will have an additional
logic board mounting hole at the top of the enclosure
that will also need to be aligned. See Figures 1, 2 & 3
for location of these holes.
5. Locate and drill #36 drill holes through the flange and
enclosure on each side of the cabinet. See Figures 1,
2 & 3 for recommended hole placement. The 16 size
enclosure will have 3 holes on both sides. The 32 & 48
size enclosure will have 4 holes on both sides.
6. Secure the flushmount assembly in place with the
provided self-tapping screws from the inside of the
cabinet into the flushmount assembly flanges using the
predrilled guide holes.
7 . Remove all metal cuttings and dust prior to power up.
Failure to do so may damage circuit board and void the
warranty.
2 Enclosure Flushmount Kit
Figure 1. 16 Size Enclosure
16 Size Flushmount
Top View of Enclosure
Make certain to
align the hole on
the flushmount
kit with the logic
board mounting
slot.
Left Side View of
Flushmount Kit & Enclosure
Make certain to align the
hole on the flushmount kit
with the logic board
mounting holes
16 Size Flushmount
Mounted on Enclosure
Left Side
Enclosure Back
Drill Here
3"
Drill Here
3"
Drill Here
6"
1/4" in from
Flushmount
edge
Top View of
Flushmount Kit
Right Side View of
Flushmount Kit & Enclosure
Make certain to align
the hole on the flushmount
kit with the logic board
mounting and lockset holes
Right Side
Enclosure Back
Drill Here
3"
Drill Here
3"
Drill Here
6"
1/4" in from
Flushmount
edge