Buffalo DA957 Manuel D'instructions page 5

Note:
• During use, the temperature indicator light will cycle on/off, indicating the set
temperature is being maintained.
• During cooking, the temperature and cooking time can be adjusted at any time.
5. When the cooking time elapses, the appliance will beep then turn Off.
Overheating protection
This appliance is featured with an overheat protection. Should the temperature exceed safe levels the
appliance will automatically cut off power.
The thermal Cut-out switch is located on the rear of the appliance. To reset the appliance after a sufficient
cool-down period:
1. Press the small reset switch down until it clicks.
2. The appliance is now reset and can be used as normal.
Cleaning, Care & Maintenance
Warning: Always turn off and disconnect the appliance from the power supply, and let it
•
cool down before cleaning and maintenance.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• For stains on the interior walls, wipe with a cloth damped with some mild soapy solution. Ensure no
moisture enters the inside of the cabinet.
• Always wipe dry after cleaning.
Cleaning the grill shelf and baking tray
• After use, remove the parts from the appliance for cleaning.
• Clean using warm, soapy water. Rinse thoroughly and dry well.
• Re-locate into the appliance.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Overheating protection is activated
Unit heats up but Bulb has expired
indicator light does
not come on
DA957_ML_A5_v2_20230329.indb 5 DA957_ML_A5_v2_20230329.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Reset the appliance
Consult a qualified technician
EN
5
2023/3/29 13:13 2023/3/29 13:13