Publicité
Les langues disponibles
Les langues disponibles
The device suitable for use in a bath or shower
This device is suitable for cleaning under an open water tap.
IPX7
This device is protected against immersion in water. Immersion of at least 30 minutes
at a depth of 1 metre.
Class III electrical equipment.
Cleaning and maintenance
Clean your beard trimmer regularly.
A regular care of your rechargeable beard trimmer and its accessories will extend the life of your
equipment.
AFTER EACH USE
Ensure that the beard trimmer is switched off. Remove the hair from the tank. Clean the product using
cloth which is slightly dampened in water. Do not use abrasive cleansers on the equipment, on the comb
or its blade. Never use hair dryer or a heater to dry the product.
Brush cleaning
The trimming comb can be removed from the main body (trimmer) and cleaned using cleaning brush
available in the box (Figure 7). Brush off carefully and blow if necessary in order to remove the remaining
beard hair on the blade. Do not use wire or abrasive brush so as not to damage the beard trimmer.
Caution on lubrication
Apply only light oil similar to the one supplied in this kit. Lubricating is must in the space between stationary
and moving blades with 1-2 drops of oil (Figure 1 n°5) which keep blades sharpness and also enhance
operating time. (Figure 8)
Comb washing
Remove the comb. Rinse it under clean running water. Allow it to dry completely.
Replacing the blade
1. Turn off your mower.
Press the blade with your thumb and push it forward in the direction of the arrow, be careful not to drop it.
(Figure 5).
2. Insert your new blade (part A Figure 6) into the slot of the mower (part B).
3. Press down until you hear a "click".
Note: For hygiene reasons, disinfect your blade regularly.
Drawing of the device
Figure 1
1
On/off button
2
USB Cable
3
Brush
4
Combs
5
Lubricating oil
www.livoo.fr
Publicité
