Johnson Pump SPX PUMProtector Traduction Du Manuel D'instruction D'origine page 8

Type designation and accessories
See page 27
Installation.
Inlet strainer for Aqua Jet pumps
• Always use a 40 mesh strainer for Aqua Jet pump serie.
• Connect PUMProtector to pump inlet with the KlickTite
quick connection.
• Connect one separate inlet port to PUMProtector housing,
by the KlickTite quick connector.
Straight connectors, ½" barb/
thread are included in PUMProtector kit. For use of port threads, cut
the barb part of the connection unit.
Other KlickTite port connectors are available as extra accessories.
See page 29.
When using solid pipework, always use an unclamped flexible hose
between solid pipework and pump/strainer unit. Recommended hose
length is 300 mm at inlet side. This is to avoid noise transfer from
pump to hull and also to achieve a more gentle operation of pump. If
the pump fails to prime, check that all joints are properly sealed.
Universal Strainer.
• Fasten the PUMProtector at a place where it is convenient to
inspect and maintain. See picture 31.
8
/ " pipe thread and ¾" barb/ ½" pipe
3
8
Original instructions