Publicité
Les langues disponibles
Les langues disponibles
1. ROOF ASSEMBLY
Begin by assembling your kennels roof frame as
shown in Fig. 1. Be sure all of the "Pop" buttons
have seated firmly. (set this aside for later)
Assembly
Quantity
Reference
of Parts
1
2
2
1
3
2
4
2
5
2
6
6
7
3
8
3
2. ASSEMBLE KENNEL
Assemble the side panels so that the two holes in the vertical
tubes are on the top Fig. 2 and the wire mesh is on the outside
of the kennel. Each connection should be held together with 3
clamp sets (2) 800215 clamps, (1) 03025 bolt, (1) 01011 washer
and (1) 01010 nut. Position each clamp set where the wire
mesh has been cut Fig. 3 and the head of the bolt should be
inside the kennel. The nut and washer should be on the outside
to ensure the safety of the animal. The side panels of the kennel
should be installed between the front and rear panel (all of the
clamps should be in the same direction as the side wall) to make
the kennel the correct size.
NOTE: It will be necessary to open the gate to install
the clamp sets for that corner of the kennel.
800248
800247
Mfg.
Part #
18104
18105
3
18107
18108
18109
18110
18111
18112
Fig. 3
800248
800248
2
5
7
1
6
7
4
Fig. 2
Note: Holes in panels
need to be on top.
800248
800215
800248
PAGE 3
1
4
Fig. 1
6
8
6
8
5
800248
03025
3
800247
800248
800248
800248
01010
01011
Publicité
