Publicité
EN – Wireless wall switch
(54501, 54511, 54502, 54512)
Install the receiver.
Install the wall switch:
1° A x the base of the transmitter with the supplied screws or double-sided tape
to the wall.
2° A x the frame to the base.
3° A x the rocker to the frame (please pay attention to position : 'UP' is
).
Dimmer Function : Push On button twice, light begins to dim. Push once again,
light stops at chosen intensity. To dim again, restart the process.
* WORKS ONLY WITH DIMMER RECEIVERS.
On/O Function : Push On (O ) button tu turn on (o ) the light or device.
Link Code :
1° Install the receiver.
2° Bring the transmitter near the receiver, push the socket learning button once.
3° Receiver led will blink slowly, push the wall switchON button.
4° Receiver connected lamp will blink twice, code is confirmed and led stops
blinking.
Delete a code :
1° Push the learning button on receiver once, led blinks slowly.
3° Push the transmitter OFF button of the wall switch.
4° Receiver connected lamp will blink twice, code is deleted and led stops
blinking. Repeat Link steps for re-setting.
Delete all memories :
1° Push the learning button on receiver for 6 seconds, led blinks.
2° Release and push again once.
3° Receiver connected lamp will blink twice, memory is erased and led stops
blinking.
* ALL PROGRAMMED MEMORY WILL BE DELETED.
Receiver has 6 memory settings :
Receiver can learn from maximum 6 di erent transmitters or channels. If memory
is full, you have to delete one or all codes. Receiver can be programmed individu-
ally or combined with other receivers (for example, one remote control controls
only the sun blind, and another switch controls both sun blinds and lamp
(connected to another Chacon module).
Fault finding:
No activation : Check battery polarity or running out battery. Check code
program sucessful. Check the module fuse. Check memory is not full (max. 6).
Caution:
Do not place two receivers near each other, the distance should be above 1
meter. Transmission distance is about 50m, but it can be reduced depending on
wall thickness and wireless environment.
Warning! Do not use in samp places. Disconnect main power before wiring
installation and fuse changing. DO NOT OVERLOAD.
Hereby CHACON declares that the device is in conformity with the essential requirements
and the other relevant disposals of the directive 1999/5/CE: .
www.chac
54501 /54502 /54511 /54512
IMPOR
rective 2002/96/EC WEEE) :
r
During the sorting of your waste, we ask you to respect the
egulations in e ect regarding their elimination.
We thank you for depositing them in a place allowed to
this purpose and respecting the environment.
Publicité
