Akai Professional G-DRIVE D2G Mode D'emploi

WARNING
The D2G G-DRIVE is designed to be used in a standard household environment.
PROTECTING YOURSELF AND THE D2G G-DRIVE
• Allow only an AKAI professional dealer or qualified professional engineer to repair or reassemble
the D2G G-DRIVE.
• Do not put, or allow anyone to put any object, especially metal objects, into the D2G G-DRIVE.
• Use only the DC power supply specified. Never use an AC power supply directly.
• If water or any other liquid is spilled into or onto the D2G G-DRIVE, disconnect the
power and/or battery, and call your dealer.
• Make sure that the unit is well-ventilated, and away from direct sunlight.
• To avoid damage to internal circuitry, as well as the external finish, keep the D2G G-DRIVE
away from sources of direct heat (stoves, radiators, etc.).
• Avoid using aerosol insecticides, etc. near the D2G G-DRIVE. They may damage the
surface, and may ignite.
• Do not use denaturated alcohol, thinner or similar chemicals to clean the D2G G-DRIVE.
They will damage the finish.
• Modification of this equipment is dangerous, and can result in the functions of the D2G G-DRIVE
being impaired. Never attempt to modify the equipment in any way.
• Make sure that the D2G G-DRIVE is always well-supported when in use on a firm level surface.
• In order to assure optimum performance of your D2G G-DRIVE, select the setup
location carefully, and make sure the equipment is used properly. Avoid setting up the D2G
G-DRIVE in the following locations:
1. In a humid or dusty environment
2. In a room with poor ventilation
3. On a surface which is not horizontal
4. Inside a vehicle such as a car, where it will be subject to vibration
5. In an extremely hot or cold environment
• Be sure to wait for a few seconds before tuning the unit on again after the power has been turned
off to ensure proper operation.
• When the battery becomes low, the unit will not operate properly. In this case, please replace the
battery with a new one.
• When you insert or replace the batteries, please turn off the power before connecting this unit to
other equipment in order to prevent malfunction or damage to speakers.
• When you connect this unit to other equipment, make sure that all of the other equipment is
turned off in order to prevent malfunction or damage to speakers.
English
All manuals and user guides at all-guides.com
English
English
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANU-
FACTURER FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
THE SYMBOLS ARE RULED BY UL STANDARDS (U.S.A.)
The lightning flash with arrowhead symbol, within an equilateral triangle,
is intended to alert the user to the presence of uninsulated "dangerous
voltage" within the product's enclosure; that may be of sufficient magni-
tude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert
the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.
Leisten Sie einen Beitrag Zum Umweltschutz
Verbrauchte Alt-Batterien die mit dem ISO-Symbolfür
Recycling gekennzeichnet sind, sowie Kein-Akkumul-atoren (wideraufladbare
Batterien), Knopfzellen und Starterbatterien, gehören nicht in den Hausmüll.
Geben Sie diese Batterien bei entsprechenden Samm-elstellen ab.
WARNING!
To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
English
I n s e r t i n g t h e b a t t e r y :
Loosen the screw and
remove the cover.
• Do not charge, heat or disassemble the battery. Do not put it in fire or water, either.
The battery may leak the electrolyte, heat up or explode.
• Take the battery out of the unit when the unit is not used for a long time.
The gas released from the battery may cause the leakage of electrolyte or may damage the unit.
• Do not mix it with other batteries or metal objects when carried, stored or discarded.
The battery may get short-circuited causing the leakage of electrolyte, heating or explosion.
• When the electrolyte gets into your eyes, as you may lose your eye sight, wash your eyes thoroughly
with clean water and see the doctor immediately. When the electrolyte gets on your skin or cloths,
as it may harm your skin, wash it off with lots of clean water.
32-En
5B-En
29A-G
1-En
Battery: 9V 006P / 6F22 / 6LR61/ 6LF22
Attach the snap fit terminal firmly
to the battery in correct polarity
as illustrated and place it in the
compartment.
Replace the cover and tighten
the screw.