Little Seeds 6828341COM Instructions D'assemblage page 32

6828341COM
6 Drawer Dresser
Step 22
IMPORTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVER. FOLLOW
THESE INSTRUCTIONS TO INSTALL THE ANTI‐TIPPING SAFETY BRACKET PROVIDED WITH THIS
PRODUCT.
WARNING
Serious or fatal crushing injuries can occur
from furniture tipover.
To prevent tipover:
* Install tipover restraint provided
* Place heaviest items in the lowest drawers
* Unless specifically designed to accommodate,
do not set TVs or other heavy objects on the
top of this product
* Never allow children to climb or hang on
drawers, door, or shelves
* Never open more than one drawer at a time
Use of tipover restraints may only reduce, but
not eliminate the risk of tipover
OPTION 1: Attachment into a wall stud (preferred method)
Using a stud finder, locate a stud in the wall. Place your unit against the wall, with the safety bracket
aligned in this location. To make driving the screw easier, you can drill a 1/8" diameter pilot hole
(3mm) through the safety bracket into the stud. Drive the screw through the safety bracket into the
wall stud. Tighten the screw that was not fully tighened in step 1.
OPTION 2: Attachment into drywall
Locate your unit where desired against a wall and mark the wall through the safety bracket, then
move your unit aside. Drill a 3/16" diameter hole (5mm) into the wallboard. Tap the wall anchor into
the hole until it is flush. Move your unit into location and fasten the wall bracket to the wall anchor
with the screw. Tighten the screw that was not fully tightened in step 1.
littleseedskids.com
11c
(x1)
11
#A84050
32
For Masonry, Concrete, or other
wall materials:
Consult your local hardware store
for appropriate anchors to
securely attach the safety bracket.
hole
11d
11c
stud
wallboard