Dealer/Owner Assembly Parts; Assembly; Cutting Blade - Francepower KTH525C Manuel Du Propriétaire

Dealer/Owner Assembly Parts

A
B
E
A. Loop Handle
B. Bracket
C. Bolts
(M5×30 For Loop Handle)
6 English
C
D
F
D. Nuts
(M5 For Loop Handle)
E. Tool Kit
F. Goggles

Assembly

Cutting Blade

DANGER
Blade angle change will be performed under the
following conditions.
●
Stop the engine.
●
Fit the cover to the cutting blade.
Setting the Angle of Cutting Blade
F
E
A
C
D
B
A. Blade angle fastening
knob
B. Blade angle holding lever
C. Blade angle turning lever
D. Screw: 2.5 N·m
E. Screw: 3.5 N·m
F. Pipe-hole
Loop Handle
Installation of the Loop Handle
B
E
C
D
A
F
A. Bracket
B. Loop Handle
C. Positioning Label
D. Pipe Assembly
E. Bolts
F. Nuts
Loop handle position
C
A B
A. Handle Position Label
B. Loop Handle
C. Pipe Assembly
●
Loosen the blade angle
fastening knob (A).
(Turn the knob
counterclockwise to rotate
about 2 times).
●
Push the blade angle holding
lever (B) and choose desired
blade angle using the blade
turning lever.
●
Firmly retighten the blade
angle fastening knob.
Place loop handle assembly at
positioning label on the pipe
assembly and tighten the 4 bolts
by using the screwdriver.
Place the loop handle over the
positioning label as pictured
below.