Amana ACS200 Serie Instructions D'installation page 2

Sealed Burner Module
Installing Module
WARNING
To avoid risk of personal injury, all controls must be in
OFF position before removing or installing
1. Turn controls to OFF position.
2. Remove grate and burner caps from module.
3. Place end of module into range or cooktop well with air
shutters facing rear of well.
• If grease pan from grill or griddle module is in well,
remove before installing burner module.
Front
4. Slide module towards rear of range or cooktop until
module engages. Lower front of module into well.
5. Place burner caps on burner base.
• Pegs in the burner base fit into recess in underside of
burnercap. To make sure cap is properly aligned and
leveled, move burner cap around on burner base.
Burner cap must be correctly seated on burner base
for proper operation of burner.
• Make sure proper cap size is on each burner base.
Burner does not burn properly if wrong size burner cap
is placed on burner base.
Rear
Well
Not centered
6. Ignite burner according to instructions in range or
cooktop Use and Care, or Owner's Manual. Properly
adjusted burner flames are clean and blue with a
distinct inner cone approximately ½ inch long.
• Burner should ignite within 4 seconds. If burner does
not ignite within 4 seconds turn control knob to OFF
position and follow directions in step 5. Try burner
again. If burner still does not ignite in 4 seconds,
contact an authorized servicer.
• If burner flame is blowing or noisy, or if burner flame is
yellow and does not hold its shape, see "Adjusting
Burner Flame" section.
A—¼ inch to ½ inch long
7. Replace burner grate when flame is properly adjusted.
2
Correct
Too large
Too small
A
Burner
Inner cone