Before You Start; Electric Wiring Diagram; Functions And Settings - Cooke & Lewis CW70 Manuel D'utilisation

Use

Before you start

01
Location
• Ensure the cooler is installed on a flat floor, with a 2cm gap on either side and a 10cm gap at the rear.
• Adjust the feet to ensure the cooler is level.
• Do not locate the appliance in direct sunshine or next to other heat sources.
• Do not place heavy articles on the top of the appliance.
02

Electric wiring diagram

1. Power input
2. Power source/temp.control board
3. Temp.NTC
4. Heat sink fan
5. Light & cold sink fan
6. Thermoelectric module

Functions and settings

01 Operation
• Before first use, the temperature control of the cooler should be set to minimum for two hours.
• After two hours, set the desired temperature and the cooler is ready for use.
GLOA10912 - Wine cooler IM A5 v5a R.indd 6
Utilisation
1.
2.
L
E
N
6
3.
4.
5.
6.
27/10/2017 11:00