Temper Kobalt KMH-01 Mode D'emploi page 19

EN
Test time： Click
600S、999S
3、After the current is selected, click "Start test", which shows that "please wait
while charging" enters the test state. After a few seconds, the test result will be
displayed, as shown in figure 3
After displaying the test results, you can click
results, you can click to directly switch the current without returning to the main interface.
After switching the current, you can wait patiently for the test results after a few seconds.
Next, you can save the test results by "local storage", or click "U disk storage" and
"print". Click "return to main page" and "return to main interface";
Test time: cycle between 10S、 30S、 45S、 60S、 300S、
Figure 3
5
KMH-01
Low resistance meter
After displaying the test