Télécharger Imprimer la page

MaxLite FlatMAX MLFP G4 Serie Mode D'emploi

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Operating Instructions
MaxLite FlatMAX
®
General Safety Information
• To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts,
cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture box
and all fixture labels.
• Commercial installation, service and maintenance of luminaires should be performed by a qualified
licensed electrician.
WARNING: RISK OF ELECTRICAL SHOCK
• DO NOT INSTALL DAMAGED PRODUCT!
• Turn off the electrical power at fuse or circuit breaker box before wiring fixture to power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and any
applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION: RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing or
performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
• Ensure fixtures are properly secured to T-bar grid, ceiling, using wire, or aircraft cable capable of
supporting 100 lbs. minimum.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS.
MLFPG4-JBOX
Models:
Using the Taller Juction Box - MLFPG4-JBOX
Note: MLFPG4-JBOX to be purchased separately.
1.
Unscrew M4 screw and remove the standard junction box cover.
2.
Fix the taller box cover properly with M4 screw.
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
LED Flat Panels (MLFPG4-JBOX)
TM
MLFPxxG4 Series - MLFPG4-JBOX
REV: 12/06/22
Page: 1

Publicité

loading

Sommaire des Matières pour MaxLite FlatMAX MLFP G4 Serie

  • Page 1 Unscrew M4 screw and remove the standard junction box cover. Fix the taller box cover properly with M4 screw. REV: 12/06/22 © Copyright 2022. MaxLite, Inc. All Rights Reserved. Page: 1 12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...
  • Page 2 Dévissez la vis M4 et retirez le couvercle de la boîte de jonction standard. Fixez correctement le couvercle de boîte plus haut avec la vis M4. REV: 12/06/22 © Droits d’auteur 2022. MaxLite, Inc. Tous droits réservés. Page: 2 12 York Ave, West Caldwell, NJ 07006 Tél: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com...

Ce manuel est également adapté pour:

Flatmax mlfpg4-jbox