Important - Dura Heat EUH4000 Instructions D'installation Et Manuel De L'utilisateur

IMPORTANT: Read all instructions and warnings carefully before
installation and use. Failure to follow these instructions may result in a
possible electric shock, injury to persons, fire hazard and will void the
warranty
OPERATING INSTRUCTIONS
Note: When using the heater for the first time, you may notice a slight emission of smoke. This is normal
and will stop after a short time. The heating element is made of steel and was coated with a layer of
protective oil during production.
Usage on outlets above 220 volts may cause a slight whistling sound due to the higher fan speed.
This results from the voltage supply. This is normal and is not affecting the operation of the heater.
This is not a defect.
1. Attached heater to wall or ceiling as noted in instructions.
2. Connect the fan heater to the proper electrical power. See grounding instructions.
3. Press power button to ON Position.
4. Set the thermostat dial to the maximum temperature.
5. Once the room reaches the desired temperature, turn the thermostat dial back until heating element turns
off. The heater will cycle automatically around this present temperature. To increase temperature, turn the
thermostat knob clockwise. To lower temperature, turn the thermostat counterclockwise.
Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock and
Immediately call a qualified service technician to inspect the appliance
"SAVE THESE INSTRUCTIONS"
Do not use this appliance if any part of it has been underwater.
and replace any part of the electrical system which has been under
injury to persons.
water.
~ 6 ~