RAB FLS-LED Instructions D'installation

FLS-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
•
Proper grounding is required to ensure personal safety.
•
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
•
Do not use this equipment for anything other than its intended purpose.
•
Servicing this equipment should be performed by qualified service personnel.
•
Save these instructions.
INSTALLATION
YOKE MOUNT
1. Fix the yoke mount to a wall using the appropriate hardware and methods for the given wall type.
2. Fix the fixture to the yoke mount with the hardware supplied. If desired, change the fixture's angle.
3. Make appropriate wiring connections as per wiring diagram.
SLIP FITTER MOUNT
1. Remove the cover from the junction compartment. Angle the slip fitter mount to a 90-degree angle for ease of fixture
installation and place on a 60mm diameter pole. Tighten the bolts on the mount's side to fix the mount to the pole.
2. Place the fixture on the mount end. Secure with hardware supplied. Pull the fixture's power cord into junction compartment.
Make appropriate wiring connections as per wiring diagram.
3. Enclose wiring connections by re-installing cover to junction compartment. If desired, change the fixture's angle.
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
2020-12-07
FOLLOW
, and these instructions
Page 1 of 3