3M SCPFWMV2 Instructions Relatives À L'installation page 11

3M ™ Folding Wall Mount SCPFWMV2 and SCPFWMSV2
14.4 Pull the cable bundle through the hole at the end of
the arm extension.
14.5 Connect the cables to the projector according to the
Quick Start Guide.
14.6 Attach the optional security cable to the projector.
15.0 Align Projector
15.1 Power on unit and change image size by adjusting the
arm extension in or out.
15.2 Adjust projector aim by loosening the thumb screw.
© 2008 3M. All Rights Reserved.
15.3 Adjust vertical image position by removing the cover,
loosening the lower mounting lag bolts or mounting
screws, and adjusting the leveling screws. Tighten the
lower mounting lag bolts or screws when finished,
and replace the cover.
15.4 To adjust horizontal image position:
1. Remove the cover.
2. Loosen the adjustment and locking screws.
3. Move the arm left or right to the desired position.
4. Tighten the adjustment and locking screws to
secure the arm in the new position.
5. Replace the cover when finished.
Adjustment Screw
Locking Screw
11