Personal Protection Equipment (Ppe); Residual Risks - Aerfast AC21025 Mode D'emploi

GB

20- PERSONAL PROTECTION EQUIPMENT (PPE)

THE AUTHORIZED OPERATORS ARE NOT ALLOWED TO WEAR CLOTHS AND ACCESSORIES THAT MAY BE ENTANGLED IN THE MACHINE.
IT IS COMPULSORY TO USE THE PPE FORESEEN BY THE MANUFACTURER.
THE AUTHORIZED OPERATORS MUST COMPULSORILY USE THE PPE FORESEEN BY THE MANUFACTURERS OF THE TOOLS USED AND ACCORDING TO THE PROCESSING TYPE.
SIGNAL COMPULSORY PPE
Hands Protection
(Heat protecting gloves)
Hearing Protection (Ear muff)
Feet protection (Footwear with reinforced cap)

21- RESIDUAL RISKS

The authorized operators shall be aware that even though the manufacturer has adopted all possible technical manufacturing precautions to make the machine safe, there is still a potential
residual risk.
RESIDUAL RISK
EXPOSURE FREQUENCY
DAMAGE RELEVANCE
TAKEN MEASURES
22- COMMAND DEVICES
They are shown in FIG. 5.
1) Power supply cable
2) Pressure switch
3) "ON-OFF" switch
4) Pressure regulator at output
5) Fast air outlet tapa
6) Pressure gauge at output
7) Tank pressure gauge
23- CHECKS BEFORE SWITCHING ON
BEFORE SWITCHING-ON OF THE MACHINE, THE AUTHORIZED OPERATORS MUST COMPULSORY PERFORM THE FOLLOWING CHECKS.
1) Make sure that there are not any non authorized person close to the machine.
2) Make sure that the safety device are integral and properly installed and working (see par. 18).
3) Make sure that the machine is properly positioned (see par. 14).
4) Make sure that the "ON-OFF" switch or selector is positioned on "OFF (0)" (see par. 22).
5) Make sure that the condensate drain valve is closed (FIG. 1 - Ref. 5).
6) Use the compulsory personal protection devices (PPE) (see par. 20).
7) Make sure that you have read and understood the "Use and Maintenance Instructions" in all its parts.
24- MACHINE SWITCHING-ON
THE AUTHORIZED OPERATORS CAN SWITCH ON THE MACHINE ONLY AFTER HAVING COMPULSORILY PERFORMED THE CHECKS DESCRIBED IN PAR. 23.
BEFORE USING THIS MACHINE, THE AUTHORIZED OPERATORS MUST READ AND UNDERSTAND THIS MANUAL IN ALL ITS PART.
DURING THE USE, IT IS COMPULSORY TO VERIFY THAT NON-AUTHORIZED PEOPLE DO NOT GET CLOSE TO THE MACHINE.
THE AUTHORIZED OPERATORS ARE NOT ALLOWED TO LET THE MACHINE UNATTENDED DURING OPERATION AND MAINTENANCE INTERVENTIONS.
HAZARD OF BURNING BY ACCIDENTAL CONTACT WITH THE BI-CYLINDRICAL PUMPING ASSEMBLY AND THE ELECTRIC MOTOR. CAUTION! THERE IS A RESIDUAL RISK (SEE PAR. 21).
THE MANUFACTURER DECLINES ALL LIABILITY FOR DAMAGES TO PERSONS, ANIMALS AND THINGS, DUE TO THE INOBSERVANCE OF THE STANDARDS AND WARNINGS DE-
SCRIBED IN THIS MANUAL.
THE MANUFACTURER DECLINES ALL LIABILITIES ON THE FINAL RESULT OF THE PROCESSING GIVEN THAT IT DEPENDS EXCLUSIVELY ON THE TYPE OF TOOL USED AND ON THE
PROFESSIONAL SKILLS OF THE AUTHORIZED OPERATORS.
TYPE OF USE
In case maintenance interventions are required without waiting that the electric motor and the bi-cylindrical
pumping element cool down.
During all processing phases.
During machine transport.
Hazard of burning by accidental contact with the bi-cylindrical pumping assembly and the electric motor.
Low and accidental. There can be exposure if the operator decides to perform voluntary a wrong action, forbidden and not reasonably foreseeable.
Light lesions (usually reversible).
Safety signs (see par. 19). / Obligation of use of the personal protection equipment (PPE) (see par. 20) and/or wait until the machine has cooled.
Fig. 5
2 3
1 1
10 10
7 7
6
4 5
6 6