CEBEK I-8 Mode D'emploi

12 V thermostat from -10 to 60º with hot-cold function. Depending on the function chosen, it activates or deactivates
the relay when the set temperature is reached. It incorporates a cold - heat mode switch, temperature adjustment
potentiometer, work indicator LED, protection against polarity inversion and connection terminals.
POWER SUPPLY : Connect the 12 VDC power supply to the POWER terminal, respecting ± polarity. Install a switch
for circuit protection and your own safety, according to CE standard.
Before activating the switch, make the rest of the circuit connections.
To power 230 V AC you can use our recommended power supplies FE-103 or FE-300.
OPERATION : Connect the sensor to the indicated terminal. If the sensor connection cable exceeds 30 cm, you must
use shielded cable.
With all circuit connections made, turn on the power switch.
Move the sensitivity adjustment potentiometer to check how the relay connects and disconnects according to the
temperature detected. The indicator led will light up when the relay is activated. With the hot-cold switch, it will allow
selecting work mode, cold mode will connect the relay when the sensor detects a temperature lower than the
adjusted one, in heat mode it will connect the relay when the sensor detects a temperature higher than the adjusted
one. To install outdoors, use a sealed plastic box to protect the circuit from water and dust.
www.cebek.com -
THERMOSTAT
TERMOSTATO
TERMOSTAT
-10 to 60ºC - 12 VDC
I-8
Technical characteristics
Voltage : 12 V. D.C.
Consumption : 5 to 60 mA
Minimum temperatude detection : -10º C
Maximum temperauture detection : 60ºC
Sensor included : NTC 10 K
Output type : Relay - NO / NC
Max. Output load : 7A ( 2A for inductive loads)
Operating Indicator Led : Yes.
Protection Inversion Polarity : Yes.
Sizes : 72 x 42 x 17mm.
Weight : 28,1 gr.
Din rail : C 7562
sat@fadisel.com