Jean Louis David Infinite Styler Mode D'emploi page 11

Replacing the trimming head
— Always switch off the appliance when replacing the
trimming head.
— Rotate the trimming head slightly counterclockwise to
disengage and remove it from the appliance.
— Attach the desired trimming head onto the appliance
and rotate it clockwise to engage it in position.
Using the cut comb
— Always switch off the appliance when attaching,
adjusting or removing the cut comb.
— Attach the cut comb onto the appliance and rotate the
cutting-length adjustment wheel to adjust the desired
cutting-length (1 - 10 mm).
Cutting / trimming hair, beards and moustaches
NOTE: Always ensure your hair / beard / moustache is clean, well combed, tangle-free and dry before using
the appliance. Do not use hair sprays, water vaporizers, shaving cream, shaving gel or any other vaporizers,
when operating the appliance.
NOTE: If you are not used to cutting or trimming hair / beards / moustaches, begin with the cut comb for a
longer hair / beard / moustache length and then reduce it, to avoid cutting more hair / beard / moustache than
desired.
NOTE: When using the appliance for the first time, first try it on an area with light hair / beard / moustache
growth.
NOTE: Use a slow and controlled movement. Do not force the appliance through the hair / beard / moustache
faster than it can cut / trim it. To control the result during cutting or trimming, regularly comb the hair / beard /
moustache in the desired style.
Trimming beards / moustaches
— Press the on/off button to switch on the appliance.
— Comb your beard / moustache in the direction of its growth.
— Make sure the trimming blades / cut comb are / is always sitting flat and parallel to the skin and not tilted.
— Slowly and carefully move the appliance against the direction of the beard / moustache growth.
— When using the cut comb, press the cut comb against your face / cheek, start by trimming the sides of your
beard / moustache. Slowly move the appliance towards the middle, trimming small amounts at a time.
— When cutting contours, position the trimming blades in a 90° angle to the skin.
— Do not switch from a parallel to a 90° position while contacting the skin.
— Avoid jerky movements while trimming.
— After the operation, press the on/off button to switch off the appliance.
Cutting hair
— Press the on/off button to switch on the appliance.
— Comb your hair in the direction of its growth.
— Press the cut comb against your head, start by cutting the sides of your hair from the bottom of the head
upwards. Slowly move the appliance up towards the top of the head, cutting small amounts at a time.
— Repeat at the back of the head.
— Cut the hair at the top of your head from front to back.
— After the operation, press the on/off button to switch off the appliance.
1.
2.
11
2.
1.