GreenWorks G40PS20 Manuel D'opérateur page 3

1 DESCRIPTION
1.1 PURPOSE
The product fitted with a cutting attachment mounted on a
pole to enable the operator to cut the branches of standing
trees but not intends for cutting woods as normal chainsaw.
This appliance is not intended for use by persons (including
children) with reduced understanding, or lack of experience
and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
1.2 OVERVIEW
Figure 1-20
Trigger
1
Lock-out button
2
Pole
3
Shoulder strap
4
Collar
5
Extension pole
6
Guide bar cover
7
Oil tank cap
8
Chain
9
10 Bar
11 Scabbard
2 SAFETY
WARNING
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
3.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
English
12 Pole saw head
13 Pole saw handle
14 Chain lubricant
15 Oil indicator
16 Battery
17 Chain cover lock
knob
18 Sprocket
19 Chain tension pin
hole
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain lubricant as follows.
IMPORTANT
Use bar and chain lubricant that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt in the
oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for 15 - 40 minutes.
IMPORTANT
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
3.3 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 10-14
1. Remove the battery pack from the machine.
2. Loose the chain cover by turning the chain cover knob
counterclockwise.
3. Remove the chain cover.
4. Put the chain drive links into the bar groove.
5. Put the chain cutters in the direction of the chain
operation.
6. Put the chain in position and make sure that the loop is
behind the guide bar.
7. Hold the chain and bar.
8. Put the chain loop around the sprocket.
9. Make sure the chain tension pin hole on the guide bar fits
correctly with the bolt.
10. Install the chain cover.
11. Tighten the chain. Refer to Adjust the chain tension.
5
NOTE
EN