Aiphone MCWSA Montage

AX, GF, GH, JA, JF, JK, KB, and KC
The MCWSA is a stand that will allow you to locate an Aiphone monitor station on a desk or
tabletop. This stand has two angle settings, enabling the user to select the optimal mounting
angle for the monitor station (45° or 60°).
Mounting:
MCWSA
MOUNTING:
1. Attach the intercom's mounting bracket to the MCWSA utilizing the appropriate set of mounting holes
(top or bottom position, see recommendations above).
2. Set the angle of the MCWSA by adjusting the rear support arm for either a 45° or 60° angle.
3. Lock the rear support arm into position to prevent the MCWSA from collapsing.
4. Feed the wires through the back of the MCWSA and attach to the intercom unit.
5. Mount the station onto the mounting bracket.
GH-1KD mounted to MCWSA
(Shown at 60°)
AX-8MV mounted at MCWSA
(Shown at 45°)
Desk Mount Stand
Use with:
JF-2MED Mounted to MCWSA
(Shown at 60°)
KB-3MRD mounted to MCWSA
(Shown at 60°)
45° Angle
Dimensions :
Face Plate : 164 x 113mm (H x l)
Base : 200 x 114 mm (L x l)
Height at 45° : 125 mm
Height at 60° : 150 mm
Recommended mounting hole position by
system:
Top : AX JA KB KC
Bottom : GF GH JF JK
60° Angle
AIPHONE CO., LTD.,NAGOYA, JAPAN
AIPHONE CORPORATION, BELLEVUE, WA, USA
AIPHONE S.A.S., LISSES-EVRY, FRANCE
Printed in USA