REED Pump Stick CP15RM Instructions

Instructions:
1. Remove the end cap and screen.
2. Take out the spacer (exposes motor unit).
3. Pull out the motor housing until the wires are taut.
4. Remove the 3 screws from the flanges of the damaged motor unit.
5. Pull out the motor unit and remove the terminals, discard the damaged
motor unit.
Reed Manufacturing Company
1425 West 8th Street
Erie, PA 16502 USA
CP15RM Motor Replacement Instructions
6. Plug the terminals into the new motor unit, being sure the red wire is
connected to the motor terminal with the red dot.
7. Insert the motor unit into the motor housing and reassemble using
the 3 screws.
8. Place the assembly into the pump housing.
9. Insert the spacer, rotate until the 3 slots engage the flanges on the
motor unit.
10. Put the screen and end cap back onto the pump housing.
Pump Stick
Phone: 800-666-3691 or 814-452-3691
Fax: 800-456-1697 or 814-455-1697
www.reedmfgco.com
™
Fig.1
0119-58142