Repairs; Introduction; Malfunction Lists; Replace Battery Catridge - Schermaschine PROFI 18266 Mode D'emploi

5. Repairs

5.1 Introduction

You can read up on troubleshooting measures on the next page . Only authorised technical personnel may
carry out troubleshooting measures marked with an *

5.2 Malfunction lists

Contact an authorised service department to repair not listed malfunctions . .
Motor component
Motor does not work
Motor heats up
Motor runs
very slowly
Motor vibrates
Motor makes very loud
running noises
Clipper head
Blade does not move
Blades cut badly
5.3 Replace battery cartridge
• Always switch off the tool before insertion or removal of the battery cartridge .
• To remove the battery cartridge, withdraw it from the clipper while pressing the buttons on both sides
of the battery cartridge .
• To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing
and slip it into place . Always insert it all the way until it locks in place with a little click . If not, it may
accidentally fall out of the tool, causing injury to you or someone around you .
• Do not use force when inserting the battery cartridge . If the battery cartridge does not slide in easily,
it is not being inserted correctly .
• A full charge takes around 1 hour .
• A full charge lasts approximately 1 hour . Battery cartridge is automatically stopped when the output
power is low ( output voltage is less than 8V) .
Cause
Battery empty
- Switches or motor defective
- Air infeed opening blocked
- Defective motor
- Battery almost empty
- Rotor runs untrue
- Bearings are worn out
- Fan wheel broken
- Bearing defective
Cause
- Blade not inserted correctly
- Upper blade or lower blade are blunt * Replace the blade
Troubleshooting
Charge/change the battery
* Have replaced by specialised workshop
Clean the air infeed opening
* Have replaced by specialised workshop
Charge/change the battery
* Have replaced by specialised workshop
* Have replaced by specialised workshop
* Have replaced by specialised workshop
* Have replaced by specialised workshop
Troubleshooting
* Check the blade and insert it correctly
* Have specialised workshop resharpen blades
Increase tension with tension screw
24