Installation - Bitspower FSP Hydro PTM+ BP-FSPHP1200-US Mode D'emploi

Installation

At first, remove the old PSU from the system case. Firstly, draw off all plugs from the PSU, that are connected
with the mainboard or other components in the PC. Now remove the screws at the back side of the case which
connects the PSU with the case. After the screws are removed, remove the old PSU from the case carefully
and replace it with your new FSP PSU.
Set the PSU into the intended position in the housing and tighten it with the supplied screws. If you purchased
a PSU with modular cables, put all necessary cables on the PSU. No need to connect cables that are not
intended to be used on the PSU.
Put the 24-pin ATX plug through
the housing to the correct
connection of the mainboard.
Connect the 8-pin plug to the
mainboard. If your mainboard
only has a 4-pin connector, then
use the 4-pin plug or split the
8-pin connector in half.
Lastly connect the peripheral
devices such as hard disks and
optical drives with 4-pin
Molex-or 15-pin SATA
connectors.
Recommended installation direction for the Hydro PTM+ (see figure below)
Recommended installation for water cooling:
① Use a 12mm connector for the cooling head
② Check the in/out direction of the water-cooling system is correctly connected
Caution: This water-cooled power supply unit must be installed by a trained professional.
For graphic cards with 6-pin
connector or connectors, use the
suitable cables. Modern graphic
cards with 8-pin connectors are
also supported. In this case, use
the other two pins beside the
regular 6-pin plug in order to
create an 8-pin connector.
1 2 m
m
02