Publicité
Les langues disponibles
Les langues disponibles
Adjusting of the light stand
EN
Loosen the locking screw of the light stand angle adjustment (5). Pull the stand
legs (9) outwards and press the stand star (6) downwards. This spreads the
legs. Set the desired angle of the legs. Fix the legs by tightening the locking
screw of the light stand angle adjustment (5) again. Note that the base of the
telescopic center column (11) should not touch the ground as this will affect
the stability of the stand.
Proceed in reverse order when folding the stand.
WARNING!
Risk of squeezing when setting up or dismantling lamp stand.
Height adjustment
The light stand is equipped with a telescopic center column that can be
extended.
The locking clamps of the center column (3) are fixed by the flip locks (4). To
adjust the height of the light stand, open the flip locks (4). Set the desired
height and close the flip locks (5) again. Press the center column elements
down to check that all locks are fixed correctly. The stand is now ready to use.
Installation of equipment on the light stand
Using the adapter on the top, you can attach devices such as studio flashes,
LED lights, softboxes, poles etc. to this stand. The locking screw must be
tightened so that it holds the thinner part of the inserted adapter pin, see
fig. A („Abb. A"). This prevents accidental release of the mounted equip-
ment. On the upper end of the mounting adapters (1, 12) a 1/4 inch thread
can be used. You can also attach suitable equipment here.
Usage notes and maintenance of the light stand
• Note that light stands generally must be placed on a sufficiently strong,
level surface to ensure maximum stability and to allow the maximum load
capacity.
• Note the maximum load capacity of your light stand model (see speci-
fications).
• Note the max. load values specified for centrally placed equipment on
the stand.
• Regular removal of sand, dust and other contaminants is recommended.
If you notice a scratching or crunching sound when moving the center
column segments, remove the impurities with a soft, damp cloth.
• Hold the center column segment tightly with one hand during the release
of the locks before you loosen its adjustment clamp.
6
Technical specifications
Walimex pro WT-802 Lamp Stand
Artikel No.
Type
Stand data
Max. working height
Min. working height
Min. packing size
Max. load capacity
Weight
No. Segments center column
No. Segments center column
extendable
Type stand locks
Ø Center column tube
segments (mm)
Ø Max. footprint
Connections
Materials
Stand tubes
Stand lock clamps
Scope of delivery
1 x Walimex pro Lamp Stand WT-802
1 x adapter 1/4 inch to 3/8 inch thread
1 x 5/8 inch spigot (16mm spigot)
1 x Transport and storage bag
1 x Manual D / EN
12524
Lamp Stand
108 cm
42 cm
41 cm
2.5 kg
570 g
3
2
Flip lock
23, 20, 17
40 cm
2 x 5/8 inch spigot (16 mm spigot)
2 x 1/4 inch thread
1 x 3/8 inch thread (via adapter)
Aluminium
Plastic
7
Publicité
