AENO DB3 Mode D'emploi page 8

about the possibility of using the device. If your gums begin to bleed after using
the device and the bleeding continues for more than seven (7) days, contact
your dentist immediately. Charge your toothbrush only on the original
charging cradle, placed on a level and stable surface. If the charging cradle
accidentally falls into water, you must first unplug it from the mains and only
then remove it from the water and dry it thoroughly. The area where the mains
cable of the charging cradle and the USB cable are located must be dry. Each
family member should use their own brush head. Replace the brush head at
least once every three months, depending on the degree of wear. Use only
original replacement tips.
ATTENTION! Do not wash the device or any part of it in the dishwasher.
Preparing the device for use
Unpack the device and place the charging station (3) on a stable horizontal
surface. Connect the charging station to the mains using a USB cable and an
AC adapter (not supplied). Place the device on the charging station. The
charging LED (4) will turn red. When the LED indicator (4) turns green, the
battery is fully charged, and the device is ready for use.
ATTENTION! The AC adapter is not included in the package. You can use the
AC adapter from your phone, tablet, or other device, if it provides power options
(DC) 5.0 V, 1.0 A.
To extend battery life, charge your device for at least 24 hours before using it
for the first time. It is recommended to wait until the battery is completely
discharged before recharging. At the end of charging, you must unplug the
charging station from the outlet. When the battery is fully charged, the
operating time of the device is about150 minutes. If you brush your teeth twice
a day for 2 minutes, the device will work without charging for up to 40
days. When the battery is discharged, the charge indicator (4) flashes red and
starts flashing slowly.
8 aeno.com/documents