Fortin PASSLOCK-SL2-H3 Guide D'installation

PASSLOCK-SL2-H3
Copyright © 2006, FORTIN AUTO RADIO INC - ALL RIGHTS RESERVED
WIRING / CONNECTION GUIDE FOR HUMMER H3 WIRING / CONNECTION GUIDE FOR HUMMER H3
H3 2006 - 2007
LED
START HERE
Make the connections of the
1
PASSLOCK-SL2-H3:
Connector 1 (Black):
1.A
Determine the type of installation:
INSTALLATION WITH
INSTALLATION WITHOUT DATA-LINK (See plan 2, Below).
Connector 2 (White):
1.B
Make the connections.
2
3
4
INSTALLATION WITH DATA-LINK INSTALLATION WITH DATA-LINK
Plan 1
In Data-Link mode the
analog Inputs (Unlock,
ground out) are disable
for security.
TECHNICAL SUPPORT / INFORMATION TECHNICAL SUPPORT / INFORMATION
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module,
except for the replacement of this module in case of manufacturing
defects. This module must be install by qualified technician. This
instruction guide may change without notice. Visit www.ifar.ca to get
latest version.
Green
2 (-) While running
Blue
Orange/Black Data In Barrel
Orange
Data from BCM
Purple/White N.C.
Purple N.C.
Yellow/Black
Yellow
Ignition +12V
1
Red
12V Battery (+)
Black
N.C.
Blue
White
INSTALLATION AND PROGRAMMATION INSTRUCTIONS INSTALLATION AND PROGRAMMATION INSTRUCTIONS
DATA-LINK (See plan 1, Below).
Press and hold the programming
button. Plug in the connector 1
(black) on the PASSLOCK-SL2-H3
interface.
Plug the connector 2 (white) into the
PASSLOCK-SL2-H3 interface.
The LED will turn on, indicating
the beginning of programming.
Starter or alarm
Data Link Port
2
1
(-) While running
Ground
Accessory
Data-Link
Data-Link
5
6
7
You have 4 seconds to complete the following procedure
8
9
10
INSTALLATION WITHOUT DATA-LINK INSTALLATION WITHOUT DATA-LINK
Plan 2
Cut off one plug of
the Data-Link
connector, connect
the red wire to +12V
and the black wire to
ground.
Technical support:
TEL: 514-255-2720
FAX: 514-255-1367
Web: www.ifar.ca
INSTALLATION GUIDE
Made in Canada - V2.1.A - December 15, 2006
W e b s i t e : h t t p : / / w w w . i f a r . c a
12V
86 85
87
87a
30
White/Yellow
V REF
White/Blue
DATA
White/Red
White/Green
Connect wire to vehicle
Connect wire to Remote-Starter/Alarm
OUTPUT
INPUT
While holding the programming
button, turn the key to the ignition
position.
The LED will flash rapidly.
Release the programming button.
Start the vehicle with the key.
The LED will flash (4 times).
Turn the key OFF.
THE PASSLOCK-SL2-H3 IS
PROGRAMMED.
Starter or alarm
2
1
Ignition
barrel
Red +12V