Hart HAC121SD Guide Rapide

WARNING!
To reduce the risk of injury, user must read and understand
the operator's manual for their lawn mower and this
instruction sheet. Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Ensure
compatibility and fit before using this accessory. Do not
use this accessory if a part is damaged or missing. If
you are not comfortable performing any of the functions
described in these instructions, take your unit to an
authorized service center.
INSTALLING THE SIDE DISCHARGE ACCESSORY
See Figures 1 - 2.
The side discharge accessory allows you to convert from rear
bagging or mulching to side discharge. To install:
 Remove start key and battery pack.
 Remove the grass bag or mulching plug, if installed.
 Place the side discharge accessory onto the mower so
the opening on the side discharge accessory covers the
rear discharge opening and the side discharge accessory's
metal locks are inside the slots on the mower housing.
 Gently push down on the side discharge accessory to
ensure the metal locks are fully seated in the slots. The
mower will not start if the metal locks are not fully seated.
 Reinstall the start key and battery pack when you are ready
to mow.
WARNING:
Keep clear of the discharge opening at all times. Keep all
bystanders, children, and pets at least 100 ft. away. Never
aim the discharge opening in the direction of people or
pets. Stop lawn mower if anyone enters the area. Failure
to follow these instructions may result in serious personal
injury.
WARNING:
Stop the lawn mower, wait until the blades come to a
complete stop, and remove start key and battery pack
before unclogging the side discharge accessory. The
cutting blades will continue to rotate for a few seconds
after the motor is shut off. Never place any part of the
body in the blade area until you are sure the blades have
stopped rotating. Contact with the moving blades can
result in serious personal injury.
Hart Consumer Products, Inc.
P.O. Box 1348, Anderson, SC 29622
1.800.776.5191 / www.HARTtools.com
HAC121SD
Side Discharge Accessory
Use with HART Model HLPM03/HLPM03VNM ONLY
FIG. 1
A
B
A - Side discharge accessory handle (poignée d'accessoire d'éjection
latérale, mango del accesorio de descarga lateral)
B - Rear discharge opening (ouverture d'éjection latérale, abertura de
descarga lateral)
FIG. 2
A
B
A - Handle (poignée, mango)
B - Slot (fente, ranura)
C - Metal lock (verrou de métal, dispositivo de seguridad de metal)
C