SAFETY PRECAUTIONS:
IMPORTANT: READ CAREFULLY BEFORE INSTALLING THE FIXTURE. RETAIN FOR FUTURE REFERENCE.
GENERAL: Upon receipt of the fixture, thoroughly inspect for any freight damage which should be brought to the attention of the delivery carrier.
100/150W
INSTALLATION:
Hook Mount
•Screw the hook into the ValueLED™ UFO High bay light fixture, then tighten securely (Figure 1).
•Hang the fixture from the hook and secure to protect the fixture from falling (Figure 2).
•After completion, please wire in accordance with all local regulations.
•You have successfully completed the installation.
½" NPT Mount
•Attach U-bracket using four supplied screws into pre-tapped holes in the top of the
housing
•Place the ½" NPT with nut through center hole in bracket and attach second nut to the
end of the NPT (Figure 3 and 4).
•After completion, please wire in accordance all local regulations. Once the installation and
wiring are complete, the luminaire can be adjusted up to 50 degrees by adjusting the
screws connected to the bracket accessory.
•Installation is now complete (Figure 5).
¾" NPT Mount
•Attach U-bracket using four supplied screws into pre-tapped holes in the top of the housing
•Unscrew the nut on a ¾" to ½" adaptor (supplied by others)
•Place the ½" end of the NPT adaptor through center hole in bracket and attach a nut to the
½" end of the NPT adaptor (Figure 6).
•Insert the incoming piece of ¾" NPT to the adaptor (Figure 7).
•After completion, please wire in accordance all local regulations. Once the installation and
wiring are complete, the luminaire can be adjusted up to 50 degrees by adjusting the screws
connected to the bracket accessory.
•Installation is now complete (Figure 8).
3597711
200/240W
Refractor
Figure 3
Figure 4
Figure 6
Figure 7
Reflector
Figure 5
Figure 8