DEFLECTA-SHIELD Challenger Instructions D'installation

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-328-5863.
Important Safety Information
WARNING:
CAUTION:
Contents
Note: Not all fasteners are used in every kit. 5/16" flat washers are used to level brackets or boards.
Clamp
5/16-18 x 1 1/2"
M-1935
X6
X6
Bracket 5/16-18
M-1934
X6
Tools Required
Wrench Set
Socket Set
SAE
Preparation Before Installation
1. Park your vehicle in a clean, level location. Check to make sure the vehicle is in park, or for
manual drive models, place the transmission in first gear. Engage the parking brake.
2. Chock one wheel on both sides with wheel chocks.
3. Unpack the bracket kit and identify the parts according to the content descriptions above.
Installation Instructions
Challenger Running Board
• To be used with Lund branded products only.
• Do not stand on Lund running board or bracket while vehicle is in motion.
• Do not exceed 350 lbs. weight on the Lund EZ bracket system.
• Do not use the Lund EZ bracket system as a jacking point for vehicle.
• Do not use Lund EZ bracket system or running boards to fasten cargo.
• Periodically check all components for tightness.
• Be sure to wear safety glasses while installing Lund EZ bracket system.
• When using power tools read and understand all operating instructions.
5/16" Washer
Rivet-Nut 5/16-18 x 1 1/2"
X12
X6
X6
Supplied Wrench
17/64"
SAE
Silicone
TM
Carriage Bolt
#14 x 3/4"
Sheet Metal Screw
X6 X6
1/4" Washer
X4
1/4-20
X16
Wheel Chocks
1/8"
Page 1 of 6
0391-09
0392-09
1/4-20
X4
1/4 x 3/4"
X20
X4
Splash Guard
Safety Glasses
10678
Rev RE
X2