Sitecom MD-394 Guide D'installation page 2

Get to know the docking station
Top view
HDD A
HDD B
Front view
Back view
MD-394 V1 001 QIG.indd 3-4
Using the docking station with your computer
1. Insert your hard disk(s) into the docking station
2. Use the USB cable to connect your docking station to your computer
3. Connect the power adapter to the docking station and the power outlet
Slot A (Source) 4. Press the power button to turn the docking station on
Using the docking station to clone (duplicate)
Slot B (Target)
hard drives
1. Disconnect the docking station from your PC
2. Insert the hard disk that contains your data into slot A (source)
3. Insert an empty hard disk into slot B (target)
! Target hard disk need to be the same size or larger than source hard disk
4. Connect the power adapter to the docking station and the power outlet
5. Press the power button to turn the docking station on
Status-LEDs
6. Wait for 10 seconds for the docking station to boot up
7. Press the clone button for 3 seconds
Clone button
8. Check the status-LEDs indicators to see the progress:
1 LED solid: 25% done
2 LEDs solid: 50% done
3 LEDs solid: 75% done
4 LEDs solid: 100% done
9. Wait until all 4 LEDs are solid. Press the power button to turn off the
USB 3.0 port
docking station.
10. Take out the hard drives carefully, hard drives may be hot.
Power Adapter
On/Off switch
27-06-16 09:46