Table des Matières
Publicité
Thank you for your trust in BWT by purchasing this softener.
iMPorTANT: before any hydraulic or electrical connection, commissioning, use or maintenance,
please read carefully this manual. The non-compliance with its instructions may void warranty.
use
This device is not designed for treating non-drinking water. Therefore, if it delivers drinking water, it
must exclusively be connected to a water supply already in compliance with the requirements set by
the applicable standards.
unpacking
Check that the device and its packing have not been damaged during transportation. Do not use the
device in case of any visible damage, and contact the vendor.
Location
The device location shall be:
•
flat, clean, dry, properly ventilated and not accessible to unauthorized persons.
•
protected from bad weather, heat sources and chemical product vapors.
interventions
The owner of the appliance holds the responsibility for making sure that any installation, care or
maintenance work is carried out by a duly authorized person, with proper skills and tools, and fully
aware of this manual content.
The work shall be performed according to the state of art and the standards applicable in the room
where the device is installed, especially regarding plumbing, electricity and handling of chemical
products (see here-below).
Plumbing
It is especially important to fit efficient water-hammer arresters if the softener input and/or output are
connected to devices likely to generate water-hammer effects (for example, solenoid valves).
electrical connection
Avoid any intermediate connecting device (extension cord, power strip) between the device and the
wall outlet.
Check the circuit compliance towards all applicable electricity standards, especially regarding electrical
grounding as well as electrical safety.
Do not try to connect the device if its power supply wire is damaged. Please contact the vendor in
order to get a new complete set of wire + transformer.
Before plugging the device to the wall outlet, cut off the power on this outlet by using the concerned
circuit breaker or by removing the concerned fuse.
If the device is installed close to any equipment with high electromagnetic parasites emissions (such
as a high power transformer), it is necessary to reinforce its standard protection towards usual para-
sites by the proper parasite arrester system and a shielded wire.
Do not open the electrical controller of the device without the proper qualification. electrocution
hazard.
reQuireMeNTs For use
Manual soFTeNer A27-A6X code P0011145 - Rev 2 - 15/03/2017
19
Publicité
Table des Matières
