Operation - Briggs & Stratton P0820B Manuel De L'opérateur

OPERATION

STARTING/STOPPING THE POWERHEAD
TO INSTALL BATTERY (See Figure 1)
■ Lift and hold up the battery door (1).
■ Place the battery (2) in the powerhead. Align ribs on
battery with grooves in the battery port.
■ Make sure the battery release button (3) snaps in
place and that battery is fully seated and secure in the
powerhead before beginning operation.
■ Insert the safety key (4).
■ Close the door.
(2)
(4)
Fig. 1
OPERATION
TO START THE POWERHEAD (See Figure 2)
Do not attempt to override the operation of the safety lock-
out button or bail lever.
■ Press and hold the safety lock-out button (1).
■ Pull the bail lever (2) upward to the handle to start the
powerhead and then release the button.
(1)
(1)
(3)
Soft-Start
This lithium-ion powerhead is equipped with a "soft-start"
feature. When initially starting up, the mower will take
approx. 3 seconds to get up to full speed.
TO STOP THE POWERHEAD
■ Release the bail lever to stop the powerhead.
■ Open the battery door.
■ Remove the safety key.
■ Press the battery release button. This will cause the
battery to raise out of the battery port slightly.
■ Remove battery.
4
WARNING
(2)
Fig. 2